I have 2 Door/Window Zigbee sensors "COEMA Door and Window Sensor, B0B6MW16HZ" connected to the bridge.
3R-installer app shows correct status CLOSE after adding them to the app but if I reboot the bridge the status goes to OPEN and stays in OPEN forever even the door/window is closed. If I open/close the window/door, the status gets updated and shows correct CLOSED.
Most likely, the bridge does not update/get the status of the sensors at boot. Since there was no activity with the sensor the wrong status stays in OPEN forever.
If I disconnect/connect battery in the sensor, the status gets fixed. Sequential reboots of the bridge doe not help.